Before the industrial decanter centrifuge is turned off, the power should be turned off and the centrifuge brake should be loosened first. When the operation is performed, the drum can be turned by hand to see if there is any biting. Check for other parts of the area for looseness and abnormality. Turn on the power and start the drive in a clockwise direction (usually about 40-60 seconds from standstill to normal operation).
Usually, every device of the centrifuge equipment must be empty for about 3 hours after it arrives at the factory. It can work without abnormal conditions. Place the material as evenly as possible. Must be operated by a person, the capacity must not exceed the rated amount. Never overspeed the machine to avoid affecting the life of the machine.
After the centrifuge equipment is started, if there is an abnormal situation, it must be stopped and inspected, and if necessary, it must be dismantled and repaired.
The centrifuge is running at high speed, so it is not possible to touch the drum with the body to prevent accidents. The mesh size of the filter cloth should be determined according to the size of the solid phase particles of the separated material, otherwise the separation effect will be affected. In addition, when installing the filter cloth, insert the filter cloth sealing ring into the drum sealing groove to prevent the material from running in.
In order to ensure the normal operation of the centrifuge, please rotate the parts every 6 months. At the same time, check the running lubrication condition of the bearing, whether there is wear phenomenon; whether the components in the brake device are worn or not, and replace it severely; the bearing cover has no oil leakage.