Home > Exhibition > Content

Operation and structural requirements of sludge dewatering decanter centrifuge

The sludge dewatering decanter centrifuge needs to evenly and evenly put the dehydrated material into the converter during the operation. Pay attention to balance, uniformity and overload, and start the motor for about 90 seconds. The machine reaches normal operation and the water outlet starts. Put a lot of water.

The machine of sludge dewatering decanter centrifuge runs for about 6-8 minutes. The outlet pipe is basically no water outflow, it can be cut off, the power supply, after 1-2 minutes, slowly brake the opening and closing arm brakes, the machine stops. The operator must be familiar with the structure, performance and operation of the machine.

The sludge dewatering decanter centrifuge needs to turn the number of turns before turning to check the condition of the turning operation. The entire equipment should be evenly distributed, so as to avoid major vibration of the machine. During normal operation, do not brake the opening and closing arm to avoid damaging the blue belt and other parts. No items can be placed on the top cover to avoid accidents after driving.

The sludge dewatering decanter centrifuge is provided with a liquid clearing chamber, a cone cylinder and a slag port switching device. The entire equipment clearing chamber is formed by an annular groove formed by connecting the conical bottom and the cylinder body, and has a clear liquid outlet pipe therein. The high-speed water stream spirally splashes onto the outer casing into the clearing chamber. The conical bottom is located at the lower part of the cylinder, and the cone tube is fixed with a feeding tube nozzle, a high-pressure water nozzle and a slag discharging port (return port), and the slag port switching device is located at the lower part of the conical bottom, which is composed of a nuclear-level valve electric device and a grounding shaft. , switch cans, cones and other components.

http://www.bscentrifuges.com/